i searched a while back and found the length needed and i believe it was 36 inches for the oil feed line. i just wanted to make sure before i ordered it today from turbonetic. i have a star kit missing a few part and one is the feed so if some one would just verify that for me i would appericate it greatly.
Anthony:+

You might be able to get away with 36...but I made mine a full 5 foot. That way I knew I had plenty to route it any where I wanted to go...and I don't have an excesive amount just hanging any where either...so 5 ft worked well for me.

i have the exact right length in a brand new oil line, lemme know if u need it ;)
_________
96 talon esi-t
san clemente, ca

The one from hahn is 36 inches I think. I recently replaced mine and i got a 48 inch one and its too long. It works fine, it just has a little extra slack.

or you could get a 60" break line and bend it like i did!