I just installed my custom 4 paddle disk and pressure plate. Well to make this short the car does not move untill the clutch is almost all the way off the floor. I know with a new clutch it should engage closer to the floor and not so farr out. It does not grab like the old CM stage 4 and just seems simply weak. It almost seems as if there's pressure on the throw out bearing to less'n the stregth of the Pressure plate there for loosing alot of clamping force. I there anything I can do to adjust for this?? Let me know if I'm not clear. In between shifts it slips I can tell and I know this is not normal with a 4 paddle disk :(

Try putting some washers between the slave cylinder and the trans case, space it off a little. That should relieve some preload off ht epressure plate, if that is indeed happening.

Good luck!