| Go back to previous topic | |
| Forum name | Turbo/Nitrous Tech |
| Topic subject | Bloody crank shaft pulley |
| Topic URL | https://forums.2gnt.com/dcboard.php?az=show_topic&forum=i8&topic_id=54377 |
|
54377, Bloody crank shaft pulley Posted by solareclipse98, Aug-19-03 06:03 PM How does one install the crank shaft pulley while engine is in the car. Please help, two very frustrated mechanics. | |
|
54378, RE: Bloody crank shaft pulley Posted by run4cvr, Aug-19-03 06:18 PM I used some WD40 and a copper mallet. | |
|
54383, RE: Bloody crank shaft pulley Posted by JustOne, Aug-19-03 06:43 PM Heat is the best trick. I just use an acetylene torch to get it nice and hot then I just slide it on w/ gloves of course. Heat it up long enough and it will slide right on w/o any pounding. | |
|
54388, RE: Bloody crank shaft pulley Posted by ner947, Aug-20-03 02:31 AM when i did my shortblock installation in february, i put my AF/X UDP in the oven at the highest tempature for about half an hour. sh!t, that thing was hot. it didn't exactly "slip right on", you'll have to use a rubber mallet or something. i was too much of a little girl to use a real hammer banging on my crankshaft - kind of reminded me of crankwalk. | |
|
54396, RE: Bloody crank shaft pulley Posted by juggalo, Aug-20-03 04:02 AM i have an installer for it. you can also use a longer bolt. | |
|
54410, RE: Bloody crank shaft pulley Posted by solareclipse98, Aug-20-03 05:36 AM >i have an installer for it. you can also use a longer bolt. | |
