Ok, I don't understand stand this so someone please help me. On the end of the fuel rail there is a cap, I un screw the cap and used a shrader tool to remove the check valve. Ok, now I'm suppose to attach a hose to it, but where does the other end of the hose attaches to? Thanks for the help.

>Ok, I don't understand stand this so someone please help me.
>On the end of the fuel rail there is a cap, I un screw the cap
>and used a shrader tool to remove the check valve. Ok, now I'm
>suppose to attach a hose to it, but where does the other end
>of the hose attaches to? Thanks for the help.

If you are reffering to a turbo setup. then you would need to get a fitting with a barbed end on it, screw that on to the port, then run fuel injection line from the port to the "in" on your sfmu or fmu.


hope that helps...

if your running Nitrous then you would put a 4AN line from there to your fuel solenoid. and if turbo, then what he said above. 4AN to your FPR or SFMU.

Hey Tim, alright I understand where the line goes, but which nipple on the CarTech? Theres one that goes down, another one that faces down with one facing to the side attached to it. I'm a major newbie at this. -=X Thanks for the help.

http://forums.2gnt.com/dcboard.php?az=show_topic&forum=8&topic_id=49437&mesg_id=49437&page=