I am deciding on getting a nitrous system..
I want to have a stealth installation, and I want easy access to it..
I was deciding installing it in the compartment, between the two front seats..

I looked at the 10 oz bottles, which are pretty good size..
I'm not just getting one, I'd get a few of them and patch them together..

Is that possible?
How hard would it be to have it like this?
Do I have a release valve for every single bottle?
Do I make a 4 to 1 line to have 4 bottles go into 1 line?

Can I patch like 4 of these systems together?..
http://store.summitracing.com/partdetail.asp?part=11824

Thanks

~Tacoman

You would need 16 of those 10oz bottles to have the same amount of N2O as 1 10lb bottle in the trunk. 1 10lb bottle only gives about 10 or so good runs at 50 to 75 shot. You could pipe a few together if you really wanted to but the price of all the fittings is really going to add up. You should be able to hook it all up with one main valve to open and close instead of one on each bottle though for ease of use and filling. You could probably hide some behind the side panels by the back seats and run all the lines through the car, sounds like a pain in the ass.



________________________________________________________________________________________
current status - unknown
Project: Baby on the way


http://hometown.aol.com/ohshootuhh/
www.Fast420A.com

just puta box over your bottle in the back or so and you'll be good

I'm with him ^^^

If you have a (sound) system in your car. cut the bottom of the box out and place the box on top of the bottle.

or

you could take your spare tire out and mount a 10lb bottle there.

i thought about the idea of what u want to do like the rx7 in the movie has its not realistic though go get 10-20 bottles filled for like 2- or 3 shots at the most and spend all the time switching it out ar that would be a pain in the arse if u ask me hide itin the spare tire well with carpeted box u could make use of the left rear removable panel that jl makes speaker boxes for????

Yeah.. I have 2 10 pounders.. and 1 15 pounder.. but I don't want to make it that obvious..

I don't want to put it in the trunk.. because of things like how cold it might be back there, and, I would need to get a bottle heater.. also, I would need a remote bottle opener, or else, get out the car, open the hatch.. close the hatch. and then get back in.. long time..
and some other things.

Thanks for the idea.. but I want to have it close and accessible to me, the driver.

Can I fit my 10 lb bottle anywhere close to the driver?

Thanks

~Tacoman

construct something to house the bottles where the back seats are.. which means removing the bottom portion of the back seats.. that way you can just reach back and open the valves....