Hey guys. I am installing an HRC stage 1 kit and I bought the vortech SFMU. What else will I need to get it to hok up properly? I know some people mentioned you can get the adapter kits at summit. Can you give me a link?

Also, is there ANYTHING else I may even possibly need? Any hoses, etc... ANYTHING? TIA. Links would eb helpful.

I just bought a new SFMU from summit, and it came with all the disks/rings, the vac restrictor, dark short spring, and instructions. You will need some AN-6 fittings to connect your fuel hoses to the SFMU, you can get those at Summit. I just used some AN-6 to hose barb fittings for the fuel line connections. That really should be it, and I always suggest purchasing the optional bleed valve for the SFMU, that screws into the "bleed" port on the top lid. You can get that from Vortech directly, or you can get it from HRC, as the FPR from the HRC kit uses the exact same bleed vavle. Actually, if you are getting the stage 1 HRC kit, then it should come with the FPR in the kit. Just use that. The bleed vlave lets you fine tune your boosted rise rate, so if you are too rich, you can open up the bleed valve to lower your fuel pressure under boost. Dont forget to use the white/black plastic vacuum check valve on the SFMU if you use the bleed valve, just copy the setup on HRC's FPR..