| Go back to previous topic | |
| Forum name | Turbo/Nitrous Tech |
| Topic subject | oil lines ASAP! |
| Topic URL | https://forums.2gnt.com/dcboard.php?az=show_topic&forum=i8&topic_id=39700 |
|
39700, oil lines ASAP! Posted by 420aturbo, Feb-23-03 05:56 AM What size socket/wrench is needed to remove the oil sensor on the back of the block? | |
|
39701, RE: oil lines ASAP! Posted by JasonESi_T, Feb-23-03 06:03 AM 1 and 1/16 Deep (Sensor) Socket. | |
|
39706, RE: oil lines ASAP! Posted by dougie2, Feb-23-03 08:05 AM I used a cresent wrench... but the engine was out of the car so I don't know if that'll work otherwise. | |
|
39718, RE: oil lines ASAP! Posted by juggalo, Feb-23-03 12:16 PM i used a 1 1/16 deep socket, got it at autozone. | |
|
39793, RE: oil lines ASAP! Posted by PiKapp504, Feb-24-03 08:52 AM Word of advice, get a swivel socket while you're at it. that'll make things MUCH easier! Also, when you tighten things back up, use PLENTY of teflon paste (not tape). Enjoy trying to get at it from underneath the car, around teh crossmember and up to the left! Also, I recommend attaching the actual feed hose from the top. If you look down right in front of the throttle body w/ a flashlight, you'll be able to get a clear shot of the place you need to screw it into. Again, good luck! | |
|
39796, RE: oil lines ASAP! Posted by Fast420A, Feb-24-03 09:19 AM 1 1/16. Teflon Paste not tape. | |
