Go back to previous topic
Forum nameTurbo/Nitrous Tech
Topic subjectoil feed help.
Topic URLhttps://forums.2gnt.com/dcboard.php?az=show_topic&forum=i8&topic_id=39643
39643, oil feed help.
Posted by 420aturbo, Feb-22-03 10:37 AM
Where do I run the oil feed line from? Where is it located on the block?
39645, RE: oil feed help.
Posted by Nitrous_RS1997, Feb-22-03 10:39 AM
You tap off of the oil sending unit on the back of the block. it has a bright green harness plugging into it. if its a star kit, it should have come with an adapter tee fitting to do this with. if not, you can get a brass one at any hardware store.

www.TeamKLR.com
1997 Silver RS
12.3@118mph,20psi, race gas(drag radials)
Wiseco 10.5 Pistons
Eagle Rods
T3/T4 Turbo
Custom FMIC
Greddy Exhaust
440's
39647, RE: oil feed help.
Posted by 420aturbo, Feb-22-03 10:51 AM
Thanks.
39649, RE: oil feed help.
Posted by green3, Feb-22-03 11:09 AM
on the oil feed line is anyone useing a oil pressure guage with there turbo set up and if you did you just tee off for all three (oil feed line, aftermarket pressure sensor, factory) Or are we able to do away with the factory. With the ECU put a code up if we dont use this
39650, RE: oil feed help.
Posted by 420aVenger, Feb-22-03 11:20 AM
Here's how I did it.