hey guys can someone please direct me or post a picture where the fpg sending unit is located. I bought a electric fuel pressure gauge, trying to install it but damit i do not know where the sender is located. Can someone please direct me in the correct place.

Thank you

laterz

depends if you have the early or late model fuel system. on 96's+ the sending unti will be a -4AN fitting at the end of the fuel rail (passanger's side) you will need to remove the schrider check valve that's inside of the port. i have no idea where the sending units are for the 95's.

ok so i get it now ther eis really no connector for it on the car. I need to put the 4n fitting at the end of the fuel rail since i have a 96 model. Then make a T connection and use one for the FPG adapter and the other is to run the SFMU is this correct guys ??

that is correct!:thumbsup