Hey guys,
Well, im in the midst of my install and i have a few questions. I trying to take the cap of my service fitting off the the fuel rail, and I was curious if there was a magical way to take it off? there is no screw or anythingits just a plastic cap, that wont eassily come off. Just wondering if I should jab a screwdriver through it or something. Anyway i am doing the install as we speak so please reply asap!
thanks,
Nick
97RS

Wish I could help you with this one Nick(my car is a 95). Sorry

get one of those tire valve remover at pep boys or so, that will remove it nicely.
good luck


Michael 99gs
HRC Stage 2
Stage 3 process begins gathering parts for rebuild

http://www.dreamwater.net/purplebeast

im pretty sure its like a valve stem cap, try twisting it off. should work....

Dwayne H
A.K.A D-low
"PAID THE COST TO BE THE BOSS"

Exterior mods:
11 peice Kaminari wide body kit* custom fiber glass hood, PHAT* supra taillights* targa top* black/blue/chrome projectors* supra double stack wing w/ Carbon fiber top deck* shaved all body lines, shaved antennas.*
Suspension: Blowjax air cylinders* 3/8 inch electric valves* 1/2 inch lines* 5gallon air tank* 2 accumlators* strut bars
Rollers and stopies: 19x8 ACE menaces, chrome 225/19/35 front 275/19/35 rear AEM big brake upgrade (front Electronics (ALL): Msd ignit.
Apexi AFC *Apexi AVC-r*Apexi Rev/speed*Greddy TT*Automete A/F* Autometer Boost* Autometer volt* Autometer Fuel presure* Autometer water temp* Autometer egt*Autometer Oil presure*Autometer cluster bezel*Autometer triple pillar pod*Playstaion 2 fiberglassed in were passenger air bag used to be 7inch wide screen LCD*4 5 inch PB speakers ( 2 per door)*2 6x9 Pb speakers*
1 15inch PB extream sub* 1 1500 us amp* the whole dash, door sills,console, panes etc, is fiberglassed. the apexi components are molded in to the dash so you only can see the face (flushed)
Brand new Hrc manifold *Brand new Hrc 16g Turbo *Turboxs RFL BOV* Custom DOwn pipe 3inch 2 N1 Apexi Canisters*( the real deal, not that Ebay bullshit)race cat *
i need a good front mount intercooler, and some bodys stage 2 piping that they dont need or i will have to get it customized J.E pistons* Eagle specialty rods*5angle port and polish cam gears crane turbo cams bore TBbore intake manny maybe some High performance valves.Underdrive pullysstage 4 clutch kit*8lb flywheel*walbro 255 490cc injectors ,chasis: 8 point rollcage with removable door bar. reinforces the roof, due to the targa top

Yea, you just grap the cap tight and unscrew it. Make sure you remove the schrader valve under that cap though, otherwise you will have a non-functioning return line.