hey everyone, well i was just wondering if i did go turbo which i do want to. ( star stage two ball bearing ).. is this all i will need besides the turbo...

Air Fuel meter
boost gauge
egt gauge apex?

is this all i will need for fuel?
greddy profe b
super afc
injectors which kind, size?
walbro 255
or
hrc inline
or both? i heard you can do both?

as far as internals goes what will i need and
around how much will i spend?
port/polish head valve job
je pistons 9:0:1
crower rods
whatelse ? i want my motor to be strong and complete so i dont have to open it up again soon...
tranny? i have a auto im died if i do go turbo... ?
thanks Michael 99gs 2gnt.com

LAST EDITED ON 05-Apr-01 AT 05:23 AM (PST)

Well I'll try a few (feel free to correct any misinfo)

is this
>all i will need besides
>the turbo...
>
>Air Fuel meter
>boost gauge
>egt gauge apex?

All you'll need to run the recommended boost (5-7psi) and turbo timer unless you dont mind sitting in your car for several minutes before shuting it down. From reading further down your post you'll need a fuel pressure gauge also.

>is this all i will need
>for fuel?
>greddy profe b
>super afc
>injectors which kind, size?
>walbro 255
>or
>hrc inline
>or both? i heard you can
>do both?

You dont need the profec b (boost controller) anything from a $50 Joe P manual to whatever you want to spend will workt to raise boost. You need the superAFC (or like fuel controller). Injector size depends on amount of boost and power you anticipate on running along with what type of boost dependent regulator you use. Either pump will work with proper selection of injector size and regulator (you dont need both if fuel system is set up properly/working within proper fuel pressure limits). You'll need to change the regulator that comes with the star kit to something more adjustable or at least something with a lower fixed ratio tban 12:1 (I'll let others ezplain all that).

>as far as internals goes what
>will i need and
>around how much will i spend?

Just pistons, rods and rings. Figure aound $1200 or so for parts
>
>port/polish head valve job
>je pistons 9:0:1
>crower rods
>whatelse ? i want my
>motor to be strong and
>complete so i dont have
>to open it up again
>soon...

You dont need the port/polish/valve job but cant hurt either. I'd save my money until I've got the turbo system running in fine tune.

>tranny? i have a auto im
>died if i do go
>turbo... ?

Dont know how well autos do but probably no worse than manuals given the number that explode without a turbo or anything else.





Stan2gnt
Stan2va@aol.com
95 Talon ES-I-NOS but T soon!
http://members.nbci.com/FlyEsi/home.htm
You too can have a never updated site complete with old info and dated pics!