i got 4 of these today off of a wreked one dose anyone now what size they aare and if i could use hem?or sell them.

They are probably similar to the DSM injectors that we can't use.


________________________________________________________________________________________
current status - unknown
Project: Baby on the way


http://hometown.aol.com/ohshootuhh/
www.Fast420A.com

but we are using DSM injectors :P Well they're chrysler DSM andway not mitsu... Ford ones work!

Mitsu cars use a low impedence peak & hold type of injector. I think they are also a lucas type.

We have a chrysler motor and use what most domestics use. high impedence, saturated, bosch type injector

This is why ford injectors work just fine. They are exactly what we have.

are are 360 cc peak and hold japanese spec (i.e. they fit in "real" mitsubishi motors like the 4g63 and the 6g72 etc). they won't fit in your car, and they are relatively too small to sell to anybody.

A.D.P.
"...If you do too much, people become dependant. If you do to little, people loose hope. If you do it right, people won't be sure you've done anything at all."
bring it on............

Check here. ....see if they work with this mod, If so let us know....

http://honda-tech.com/zerothread?id=216710

it would be a lot easier to use a resistor pack off of a factory turbo car, but irregardless, the injectors won't fit. they have no lower o-ring.

A.D.P.
"...If you do too much, people become dependant. If you do to little, people loose hope. If you do it right, people won't be sure you've done anything at all."
bring it on............