Go back to previous topic
Forum nameTurbo/Nitrous Tech
Topic subjectBarb for HRC stage 1 FPR
Topic URLhttps://forums.2gnt.com/dcboard.php?az=show_topic&forum=i8&topic_id=32455
32455, Barb for HRC stage 1 FPR
Posted by fatchance, Oct-09-02 03:59 PM
The larger barbs for the FPR what size thread are they? it's smaller than 1/4 inch but I was hoping someone knew.

TIA

Phil
32456, RE: Barb for HRC stage 1 FPR
Posted by Corbin, Oct-10-02 03:53 AM
Pretty sure that the fuel fittings are standard NPT. So that means 1/8" or 3/16" NPT. Don't forget to use teflon paste.

Corbin

'95 ESI-T
HRC+FMIC+ETC...



Gimme fuel...Gimme fire...Gimme that which I desire

Parts Collected for next engine:
2.4l PT Turbo pistons
2.4l PT Turbo rods
2 Rolls duct tape
32457, RE: Barb for HRC stage 1 FPR
Posted by eclipsekaiser, Oct-11-02 03:30 PM
1/8th NPT