okay will i get any creep on a s16g at 15 psi? i am having a little issue right now. my avcr may be the problem. well, if i put the car in any gear, say 3rd. and floor it the boost rises to my preset number, then after a second or so it spikes. my controller is set at .8 bar, and it has spiked to .95 bar once while doing this, but at lower boost settings it is fine, do you think its my boost controller or am i getting creep?
thanks
james

no. the turbine housing is too big to get boost creep in your situation.

A.D.P.
"...If you do too much, people become dependant. If you do to little, people loose hope. If you do it right, people won't be sure you've done anything at all."
bring it on............

However I think the Stock Hahn/Mitsu Dp can contribute to this problme of boost creep. Not enough flow....:P

Check your AVCR James and let us know.

I haven't experienced any boost creep from my Super 16G. Unless you have a 3" dp, you might want to check the AVC-R. I experienced boost spike around 15-17 psi, but that was because of my manual boost controller.

okay, my avc-r went into self learn mode
and now it don't do it anymore, i think i haven't drove it hard enough before for it to do that so the avcr hasn't had time to learn that rpm. so now it is steadily coming down it used to hit .95 now it only hits .9 and i bet if i drive it more it will eventually get down to .8, but fuck that i'm going to turn it up to 1.0 bar, its ready for it.
lates
james

1.0 bar is 14.7 psi of boost......FYI