I hooked a momentary push button in between a 12v+ power source and the yellow/white wire of the Crane ignition. Is this correct? Is there anything else to wire up, because it's not working.

I have the stage one dial set to 0,3K for a 3K rev limit. Any ideas?

I was getting the same thing. I had it hooked up to a 12v and got nothing. What I ended up doing it running it off the pos battery post, to the switch, to the Crane. Worked/works fine so far. I did the same thing for the 2nd stage but I didn't intall a switch I use it as a soft limiter set at 7k. when you hit the soft limiter its not like hitting a wall like you do when you hit the factory rev limiter. (thanks Greg) ;-)

try hooking it up off the battery if it doesn't work then something is wrong.

Brian

Yeah make sure you are using a higher current 12v source, might not be strong enough to trip the rev limiter.

Una salus victus.
He will triumph, who knows when to fight, and when not to fight. - Sun Tzu

Michael J. Kulaga
e-mail: Michael_97RS@2gntDSM.zzn.com aol IM: MJKulga
http://highlander.dsmpower.com/

All motor in the making.

Injen CAI, 55mm TB, P&P Intake Manifold, Crower Stage 2 Cams, Hooker Header, GS-T Muffler, AFX UDP, S-AFC, 8.5mm Magnecor Wires, Crane Fireball HI-6DI2, FU/RU/RL STBs, TSW Blade 17x7.5, Bridgestone Potenza RE730, Front KVR Cross-Drilled Rotors & Carbon Fiber Pads

To Be Installed: P&P Milled Head, Rear Disc Brakes, Rear KVR Cross Drilled Rotors & Carbon Fiber Kevlar Pads, SS Brake Lines

Thanks for the responses guys. I finally figured out the problem. My 12v+ source was good; I had the rotary knobs set wrong. For the stage one rev limit, it was set at 0, 4, which is only rev limiting at 400 rpm. I now have the 1st knob set at 4K, zero for the 2nd knob. So now, when I engage the button and rev up to 4K rpm, it limits the rpm at 4K. It gives off a pretty awesome pop, pop, pop, sound.