has anyone come up with a better connection for the inline pump to the stock fuel line.

I'm a little curious about the ability of those 2 clamps to hold onto the stock fuel line.

Any thoughts, comments.

mines been holding fine for over 9 months....no leaks anywhere... knock on wood

Yes, in fact, I was able to replace the rubber line there with an Aeromotive SS Fuel line with either a 6 AN or a 4AN Aeromotive fitting. The stock hard feed line there also has a female fitament for an AN fitting. It's nice and tight there with no more worries.

More importantly, I was constantly anal about fuel line kinks down there. Save for the line from the fuel filter to the fuel tank assembly, it's all SS down there now. I just cut back some of the SS line where necessary if I needed to use hose clamps. Otherwise, I tried to employ AN fittings everywhere.

Jason, I'm all ears. Got any pictures?

Well, since it's all put back together, there's not much to look at with the shield below the inline fuel pump and such. However, I will try and get a picture of the SS fuel line mating with the stock fuel line.