| Go back to previous topic |
| Forum name | Turbo/Nitrous Tech |
| Topic subject | 3 angle valve job question |
| Topic URL | https://forums.2gnt.com/dcboard.php?az=show_topic&forum=i8&topic_id=21952 |
21952, 3 angle valve job question
Posted by Dave_FL, May-12-02 12:06 PM
I am goign to get a 3 angle valve job on my head. Do I need to get valve seals for this to be done? Do i need anything else for this head work?
|
21953, RE: 3 angle valve job question
Posted by Dave_FL, May-12-02 09:24 PM
BUMP
|
21954, RE: 3 angle valve job question
Posted by speedracer21, May-13-02 12:58 AM
yea i think you should get new ones. cause i'm pretty sure that they remove the vlaves to do the grind, so it would be a good idea to get new ones, plus then you can have the head hot tanked to really clean it.
|
21955, RE: 3 angle valve job question
Posted by rpm97talon, May-13-02 02:53 AM
when they remove the head to do the tear down, seals and gaskets should be rplaced. The valve seals themselve look like a little boot held inplace around the valve by what looks like an O shaped spring. yes replace all you can cause you never want to take the head off after rebuild. late mike
|