How do i run the vc2,,,,do i run it to the mass sensor that runs to the manifold? if i do which color wire do i tap into??? Or do i run into the Ecu itself by which harness to i tap into the top harness or the bottom. Please help me i need the VC2 hooked up because im running lean and i have a road trip ........thanx for everything john


on my vc2 the wires correspond as follows: blue/red wire connects to the Air/Flow sensor Input of ECU,........the solid blue wire connects to the Air/Flow sensor Output of ECU......then i have a negative wire to the battery, and a red wire to the ignition switch...
the last time i tried running into a wire in the mass sensor it made car overheat,probably because it was the wron wire someone please help me,,,,,,,,,,,,,,where is the Air/Flow sensor of the ecu??

Don't double post. or triple, either.

Yellow wire black stripe in the ECU wiring harness. That's the MAP sensor wire.

thanx dino, my bad noone seems to answer around here