to help strauss someone please write up some quick install directions for easy installation on the air/ fuel ratio....guage...
thanx i need help too!

I also want to know how to install the boost guage, and water temp..

http://www.2gnt.com/dcforum/DCForumID25/4480.html

I got it right this time Dino and Jason :P

Find your ecu
unplug the top plug into the ecu
remove the coverin gover the wires
find the white wire with black stripe
splice
run the purple wire from the a/f gauge to this
secure with electrical tape
plug back in
watch it go blinky blink

power - the is a green wire that goes to your cigarette lighter
ground - undo the kick panel and there should be a screw there that I like to use as a ground

the proper way of doing it is to spend a little more money. Go buy a weld in bung and a single wire o2 sensor. run the purple wire to that then your power and ground. As for the boost guage, just run the line to a vacuum sorce after the throttlebody and of course the power and ground for the light. For the water temp? there is a plug on the back of the block just to the right of your oil feed,just find the right reducer and install the sender,and again you'll need to run power and ground for the light. It might also help quite a bit if you run some relays especially if you plan on getting more guages. late mike