I went to put on my straight pipe today and I didnt because when I loked under the car I saw that the stock cat holds up the middle of my exhaust piping. If I put in the straight pipe the middle will sag down. I have a flex section on the downpipe so if there is nothing holding it up I think it will be too low. Anyone have any suggestions on what I could do? I was thinking about rigging something up like a hanger to hold the straight pipe. But that is kinda ghetto if you ask me.

hmmmm... i think you should take a ride up to Glen? no?

yeah well i got a 3 inch high flow slip fit and just bought a clamp with a hanger on it and it matched up nice...ghetto yet functional.

>yeah well i got a 3 inch high flow slip fit and just bought
>a clamp with a hanger on it and it matched up nice...ghetto
>yet functional.

Whats a high flow slip fit? And where did you get a clamp with a hanger on it?

BTW, what should I do with the 2nd O2 sensor if I'd take the cat off??

Why dont you goto a machine shop and have them fabricate some kind of clamp and weld it to the straight pipe??

>yeah well i got a 3 inch high flow slip fit and just bought
>a clamp with a hanger on it and it matched up nice...ghetto
>yet functional.

Can you run a high-flow cat with cam2???