I ordered the same boost controller you have. It is the fastforward one. I have seen pics of it mounted but I cant tell where it is mounted because the picture is too close. Where did you mount yours and did you have to buy anything extra to mount it? I am very good with sheet metal so fabricating wouldnt be a problem if necassary

I really didn't do a whole tremendous great job in mounting my BC, as I just looked for a place close to to former position of the air box and stuck it there. AS you'll notice with the BC, it has a large nut that comes off the top of it. What I would like to do, but haven't, is just find an L-shaped bracket that will, one, mate with the BC so that the top of the BC and nut can adhere to the bracket, and two, use a 10mm or so bolt to adhere the other end of the bracket to one of those vacant bolt holes on the vertical metal side to where to the air box used to attach. That seems to be a good location in terms of proximity relative to the both the compressor and the BOV line. There's also room there. :-)

Right now, I've just used that nut on top of the BC to ghetto tie wrap it at the same location described above. Oh yes, remember that picture to the setup used at FFWD is one from a 4g63.