| Go back to previous topic |
| Forum name | Turbo/Nitrous Tech |
| Topic subject | all stage 3 or higher 2gnt peeps!! |
| Topic URL | https://forums.2gnt.com/dcboard.php?az=show_topic&forum=i8&topic_id=13685 |
13685, all stage 3 or higher 2gnt peeps!!
Posted by icedout, Jan-18-02 04:24 AM
hey guys and gals I'm trying to get an overall pic on which set up it better for internals. Can everyone that has upgraded their internals please post their compression ratio. 8:6.1, 10:6.1 etc...and which type of set up you went with je pistons and crowler rods or eagle rods.
tia
|
13686, RE: all stage 3 or higher 2gnt peeps!!
Posted by DarkOne, Jan-18-02 05:06 AM
i went with 8.8:1 compression JE's and Crower rods. (HRC) I'm currently making more power than my CFDF can handle.
|
13687, RE: all stage 3 or higher 2gnt peeps!!
Posted by 992gnt, Jan-18-02 07:21 AM
9.5:1 JE's and Crower rods. Should be good for 400+hp.
|
13688, RE: all stage 3 or higher 2gnt peeps!!
Posted by HadesOmega, Jan-18-02 08:24 AM
nice picture dude, what region do you autox in?
|
13689, RE: all stage 3 or higher 2gnt peeps!!
Posted by vegasdsmr, Jan-18-02 08:32 AM
and is your pass side front wheel off the ground??? looks like it.
tia
|
13690, RE: all stage 3 or higher 2gnt peeps!!
Posted by JustOne, Jan-18-02 04:44 PM
JE pistons 8.6:1 .020 over, Eagle forged rods, total seal rings.
Project just getting started.
|
13691, RE: Just One
Posted by esi420, Jan-18-02 05:32 PM
Hey, Just One
I just got the same thing-Howell Bottom end kit with 8.6 pistons and eagle rods. Also got an HRC stage 2. What kind of boost are you shooting for?
Later
|
13692, RE: Just One
Posted by JustOne, Jan-19-02 03:08 AM
Right now I am boosting 6 psi but that isn’t enough for me so I am shooting for 20+ psi. I just have to make sure I have all the other issues worked out. I.e. fuel management and timing.
I think I am going to go w/ the accel dfi, s-fmu, crane fireball, and two pumps (the jury is still out on that one though)
I still need to figure out what I am going to do as far as headwork goes. I don't know if I want to port it out because everyone who has done so seems to have a rough idle.
|
13693, RE: all stage 3 or higher 2gnt peeps!!
Posted by 992gnt, Jan-19-02 02:03 PM
That was in the NEOhio region last summer. I now auto-x with the Cincinnati SCCA region. And yes, I think the wheel is awfully close to being completely off the ground. God knows it spun enough. :7 That was also before my car was boosted. Can't wait to try out 400 hp around the cones.
|