I finally went to do the dyno I paid for awhile ago. I was just waiting to install gauges (backorder on lotek pod). Anyway I hit 191.7 Horsepower @ about 6000 rpm and 193 Torque @ 4000 rpm then it dropped gradually. I kept it at 7 psi to be safe. I plan on getting a bigger downpipe and putting on my 3" cat. With those the car will be over 200 at 7psi, so depending on funds I will dyno again after those 2 mods and maybe up the boost a little to see the difference.

nice numbers man.


aka:dsm1

That's very good at 7psi. Good tuning.

that's @the wheels right? I would think it's be more around a stock GST if it was at the crank.

>that's @the wheels right? I would think it's be more around
>a stock GST if it was at the crank.

A stock GST puts down 165-175hp to the wheels so its a bit better than what a stock GST is putting down.

Nice Numbers Bro!

Damn I want some freaken boost, I hate the save and wait game! O well just a matter of time.

very nice man... keep it at near 7psi to keep it safe. good luck!


96RS ~ full 99GS special body conversion, aem cai, greddy header, greddy sp exhaust, afx pulley, b&m sS, magecores & NGKs, S-AFC, Sparco Torino, illuminas, prokits, ingalls camber, gunmetal GS rims, ST Sways, STBs, lower rear tie bar, sound system, a shit load more.

97 ~ GSX stock for cock for now but smokes (for the haters) MY 420a. To all the haters _|_ tia

yo should save for some internals dood

It is definitely better than a stock GS-T and it should look way better at the top end where a T-25 like to fall on its face. Good numbers for that boost btw. I made about the same at 7psi. I forget what it actually was now.

Nice Numbers, your knocking on a modded GST's door. My car put down 210&236 with just bolt on's and 16psi. Good Luck.

Derek

i put down 240.2 hp and 217.3 torque @ 10 PSI on the dyno at the carlisle show this past may. this was with the star kit, 3" testpipe, and 3" thermal exhaust. not too bad of numbers i would say.

Jason
95 GS Turbo
Car is for sale.