Go back to previous topic
Forum nameTurbo/Nitrous Tech
Topic subjectPulling timing
Topic URLhttp://forums.2gnt.com/dcboard.php?az=show_topic&forum=8&topic_id=109678&mesg_id=109678
109678, Pulling timing
Posted by flamineclipse, Dec-31-69 06:00 PM
What's up guys? It's been a long time since I've posted. I just got my car running again and I have a few questions about pulling timing for higher boost. Here is a quick rundown of whats been done to the car.

JE 8:8:1 pistons
Eagle Rods
Melling Oil Pump
Arp Hardware
Hahn S20g
PortFueler
MSD coil
MSD wires
Stock Head and cams
Spec stage 3 clutch

I have a 15 PSI wastegate actuator that is showing 17-18 psi at full boost on my mechanical boost gauge. I do not hear any knocking at these levels. I would like to turn it up to 20 and beyond at some point. I have been looking for a solution to pull timing at higher boost levels and I'm not having any luck. MSD has ceased production of the 6212 and have no alternative. What would you suggest?


I generated this page in 0.0075170993804932 seconds, executing 6 queries.