well i got a fuel pressure guage for my 95 and im wondering where i connect the pressure sending unit that came with the guage?plz input

If you're a 95, you should have a service port on the passenger side of the fuel rail. It will be facing upward with a black cap on it. It has a small valve that you need a tool to remove. Once removed, get a -4an to 1/8"npt reducer, you'll probably only find female to male, so you'll also need a female to female 1/8npt coupler. Attach your sender to that. That should be all.

Originally posted by DirtMegirt
If you're a 95, you should have a service port on the passenger side of the fuel rail. It will be facing upward with a black cap on it. It has a small valve that you need a tool to remove. Once removed, get a -4an to 1/8"npt reducer, you'll probably only find female to male, so you'll also need a female to female 1/8npt coupler. Attach your sender to that. That should be all.

could i get it all at home depot?

no

home depot dosent have AN fittings
although they do have the schrader valve core removal tool you will need to take out the core of the test port (although a pair of needle nose can do the job)
try Jegs or Summit for your stuff or www.anplumbing.com/

Aeroquip part numbers
-4 to -4 female flare swivel = FCM2914
-4 male AN to Female 1/8 NPT = FCM2721

and BE CAREFUL when you tighten them down, AN fittigns are just finger tight plus 1/4 turn thats it! i sheared the port off my first rail because of tightning issues. (adapter was cracked and leaking i thought it was the conection so i kept tightning)

Originally posted by foggy45
no home depot dosent have AN fittings although they do have the schrader valve core removal tool you will need to take out the core of the test port (although a pair of needle nose can do the job) try Jegs or Summit for your stuff or www.anplumbing.com/ Aeroquip part numbers -4 to -4 female flare swivel = FCM2914 -4 male AN to Female 1/8 NPT = FCM2721 and BE CAREFUL when you tighten them down, AN fittigns are just finger tight plus 1/4 turn thats it! i sheared the port off my first rail because of tightning issues. (adapter was cracked and leaking i thought it was the conection so i kept tightning)

where are those part numbers for?i tried anplumbing.com but there was no match?

Aeroquip parts catalog (PDF)
http://www.aeroquip.com/media/performance/A-SPPE-MC001-E-p5-8.pdf
i just call my order in to the local speed shop and they order the parts.

i think anplumbing uses Earls fittings which there catalog is here
http://www.holley.com/division/Earls.asp

well after istalling all it seems the -4 an to -4an female swivel was leaking quite a bit of fuel so i wraped it with threading tape then tried cranking it but the fuel is leaking in the middle where it swivels and not where the threads are?i tightend it tight but not to tight because i didnt wana strip it out???any advise

send me a pic of the leak