wow i just tried to make a post with all of my pictures but internet explorer just shut off, and it took forever, so I'm just going to give you the link to my webshots and you can look at it all there because i don't feel like posting that again. so here you go
http://community.webshots.com/user/cmas00 enjoy!


As i was reading through the directions and kind of putting stuff together on my floor just to see how it goes, I think I'm missing some parts for the turbo's oil feed inlet. Well i have the peices, i just think they're the wrong ones, because the 90 degree elbow provided doesnt match up to the oil feed fitting provided. Either the elbow is too small, or the fitting is too large on that end. Did anyone else encounter this? I checked through all of my other fitting bags and couldn't find something that fit right, so i'm pretty sure that i need to call hahn and get them to send another over.

And everyones suggestions or warning or whatever is greatly appreciated. I feel more than capable to do this project, but like you all said, this is a lot of money, and I'm not going to be cocky about it, so I'll take as much help and advice from people who have been through it as I can!