80322, RE: Throw Some Info Down About Your Turbo Setup
Posted by Matt_95tgs, Dec-31-69 06:00 PM
1995 gs
JE Pistons
Eagle Rods
Clevitte 77 main and rod bearings
Total Seal rings
Melling oil pump
Fidanza aluminum Flywheel
SPEC stage 3 pressure plate
Custom clutch disk
Fidanza cam gears
ARP head studs
Crane #14 cams
Eaton PT lifters
Eaton PT rockers
Ported and polished head
Ported and polished intake manifold
Jeep 62mm TB
034EIC 8 injector setup
Crane ignition
MSD blaster coil
MSD wires
HRC front mount IC
Greddy Type-S BOV
Forced Performance Red turbo
Custom equal length SS exhaust manifold
2.5" turbo back exhaust
Walbro 255 lph high pressure fuel pump
Aeromotive 1:1 regulator
Autometer gauges (boost, egt, a/f, fuel pressure)
Hallman MBC
Eibach Springs
KYB AGX shocks
Konig Blatant 17" rims
Kumho Exsta Supra tires
Front and rear Camber kits
160 degree thermostat
I'm just starting the install on the equal length manifold with the forced performance Red turbo. I don't have that running yet, but I've been running the HRC log manifold with the S16g for a long time.
|