>I had no idea where to put the hole. I figured it would be
>fine since theres significant pressure from the feed line from
>the block. Is it still not enough? I was also worried about
>clearing the engine internals... I had no idea if they
>protrude into that part of the pan or anything...
>
>Well there is not a whole lot of pressure in the drain. In the feed yes, but once it goes through the turbo, it has very little pressure. Internals should not be an issue. The best place to put it is at the top of the pan, prefrably on the flattest part you can fine, to help it seal well.