Go back to previous topic
Forum nameInterior/Exterior
Topic subjectRE: Can someone please tell me what the procedure for dying the interior pannels are?
Topic URLhttp://forums.2gnt.com/dcboard.php?az=show_topic&forum=7&topic_id=99263&mesg_id=99277
99277, RE: Can someone please tell me what the procedure for dying the interior pannels are?
Posted by cs82685, Dec-31-69 06:00 PM
Originally posted by 505racer
Originally posted by RoninEclipse2G
Originally posted by eclipse982nrRSTGood Luck finding a set of oe black door panels. And when you do, they are $3-500 on ebay easily. I know because I have been looking for a set for about 8 months now.
yup, full black interiors are rarer than my wife's porsche (1000 made) and are worth their weight in precious metals
so its not jus somthing you can go order at the dealership or anything


You can if you want to pay an arm and a leg

Side note, I got my black door panels for $100 shipped, but they are not power door panels. There's also a black dash I've got my eye on at the local junkyard but cash is much shorter than I thought :(

Back on topic, I used the duplicolor vinyl/fabric spray on the covers for the taillights in the trunk just as a test and when I got my black door panels I compared and it matched perfectly (Flat black). All I did was clean the parts up with some soap and water and spray on a few light coats. Because I didn't sand, the pieces still have that textured look they have from the factory. Sure these aren't pieces I've tested for durability, hell they don't even see sunlight, but I am very tempted to now use the stuff on any interior piece that doesn't see too much action, such as all the panels in the rear seat and the pillars.
I generated this page in 0.0087909698486328 seconds, executing 6 queries.