Well after reinstalling my new front bumper I didnt put the plastic clips in the fender liner and the part by the front of the tire I guess kept rubbing up against the tire because the wind blew it into the tire and both sides are shredded.

Does anyone know the part number or wear I can by both fender liners. I checked partstrain.com and found the "splash guard" but wasn't sure if that went all the way down the bottom of the bumper or if it was just PART of the liner. Any help would be greatly appreciated. Thank you!

Originally posted by clipse_2005
Well after reinstalling my new front bumper I didnt put the plastic clips in the fender liner and the part by the front of the tire I guess kept rubbing up against the tire because the wind blew it into the tire and both sides are shredded. Does anyone know the part number or wear I can by both fender liners. I checked partstrain.com and found the "splash guard" but wasn't sure if that went all the way down the bottom of the bumper or if it was just PART of the liner. Any help would be greatly appreciated. Thank you!

hahahahaha . mine too

Yea its a bitch to keep looking at it everytime I get out of the car and the hole keeps getting bigger and bigger. I just checked machv.com and they have them for $25 per each side and its only $7-8 shipped for both of them combined. aka... $57-8 for both sides shipped. Pretty good deal in my opinion! Then I guess I should just get the little plastic clips from the dealer.

I got mine from my local dealer for $25 WITH the plastic clips and hardware.

For one or both of them? Either way that sounds like an easier alternative than going through machv. You mean just your local mitsu dealer?

$25 per side. And yes it was from my local dealership.