Well I recently purchase a set of oem foglights, the first question is i would like to use the oem switch cause i found on at the junkyard i also have the plug that goes into the switch with extra wire hanging off of it(You will see in the picture), my next question is how can i get the screws off of the foglight to switch the bulbs because the some screws got striped from the previous owner. pics below, thanks

If it was me, I would dremel the heads off and if there was a little meat left after the housing was off try and vice grip them out or drill them out and replace with self tappers once the bulb was changed.

thanks i will keep that in mind, ima wait see if anyone else has any idea.

This recently happened to my drivers side when I was replacing the bulbs for the third time. I was gonna cut it off/easy out the screw but my smallest easy out broke off. So I was really mad and luckily it was only 1 screw. So i bent the bitch back far enough to allow me to take the light out/put new one in. Then I bent it back into place and tightened the other 2 screws. Next time the bulbs go out... Yeah. Not sure yet.

if ur close to me ,bring em by my house, well have that in in about an hour