I took out my center heater vent to make a plexi-glass panel for my nitrous gauge, switch, and purge button. What would i use to block off the heat from going back there? Can i use a piece of foam to put in there so it routes the heat to the door vents? or would it get to hot?
Thanks

i dunno, maybe cut a piece of plastic to fit over the vents and super glue it in place or something :shrug

thanks. You think it will get too hot though?

Originally posted by willy
thanks. You think it will get too hot though?

Does your face melt off when you turn on the heater or something? Doesn't get that hot...

yeah, its not that hot. just get some hard plastic and super glue it....we arent talking high temps here. just a quick google search indicated that most plastics can withstand 200* temps before melting. i guess if your too parenoid hold a hair dryer (overkill) to it and look for any warpage or anything. you could stuff a rag down there first, then seal it up, but youll be fine. your car shouldent spontaneously combust :P

disclaimer: 96eclipse2nr shall not be held responsible if the vehicle in question WERE to accidently combust :dark

Or you could just not worry about it. Ive had mine out for years and have never had a problem...and you wont either, unless your running NO2 through your heater vents.

Originally posted by DJ420a
Or you could just not worry about it. Ive had mine out for years and have never had a problem...and you wont either, unless your running NO2 through your heater vents.

I love it---the new ricer rage----nitrous heater

You could route the center heater vents to your nos bottle and have a custom nos bottle heater. :thumbsup I'm definitely kidding....

nitrous heater idea sounds good. ha! thanks for the ideas guys. i think i will just cover it up then with a little plastic cover.