I have my hatch covered in Dynomat and I'm about to repaint my car and shaving everything in the process, including loosing the toenail spoiler.

To minimize how many holes I have to put in my Dynomat can someone post a pic of the bolt locations to the toenail spoiler?

I'll definately be giving some big points. Thanks in Advance!

this shows the holes from the topside of the trunk
http://forums.2gnt.com/dcboard.php?az=show_topic&forum=7&topic_id=72856&mesg_id=72856&listing_type=search
There is the blue car at the top that shows the holes from the passenger side and the gray on the bottom that shows them from the drivers side.
Using your rear windshield wiper motor as a reference, they should be easy to find. There is six holes, two that are almost even with the rear wiper motor, one right next to the right one but further upwards, and one off to the far right. The driver's side ones... one right near the wiper motor, one further up. I only remember this from tightening these bolts though, because my last system rattled them loose, and I might be a bit off on the driver's side ones. I am not sure if there is one on the sloped part of the hatch or not...

The easiest way to double check this would be to uninstall the wing right now, and shine some light through the other side. The dynamat will have to get holes punched in it or ripped off to remove the spoiler anyway, and dynamat doesn't come off once you put it on. Save yourself the trouble now, IMHO.