Well, not actually the glovebox itself. It's the platic brackets that the glove box bolts to in the back. The plastic is broken on both sides so the only way my glovebox is staying up it the latch. What would be the best way of fixing this? The brackets are a part of the dash assembly, so I can't replace those. I was thinking of just JB Welding another peice of plastic behind the holes and using longer screws. If anyone has a better idea than this let me know. I was planning on just living with it until I finished my new dash project, but Fedex broke the hell out of the dash I ordered. Any help would be appreciated. TIA guys.

you could probly find anotherbracket at a junkyard, but until then jb weld away my friend.

mine is semi broken too. whenever i open it i have to stop it from overtraveling...otherwise it will go upside down and dump all my shit n the floorboard....kinda sux

keep checking ebay...that's where I got mine. It's alot cheaper than going to the dealer. But if you've got a local junkyard then go there...As said above^^^

the funny thing is that happend to me yesterday and i finally got it working again by using those plastic TIE WRAPS. just find hole to put them together. and so far i dont have to worry about them brackets...


hope this helps

Yah I drilled holes in back and used tie wraps and nails and it works fine.