I recieved my brackets and sliders in the mail today from Fedex. The tab on the sliders does not fit into the slot on the brackets to adjust the sliders lower. I can only get into the highest setting on the sliders. The tab is about 1/4" too wide to fit in the slot. What do you guys think about grinding the tab down a little bit, or opening up the slot a little bit to be able to fit the tab down into the slot and allow the lowest or middle height setting? I have heard people say that the lowest you can go is the middle setting, why is this? By looking at the brackets and sliders I don't see any reason you can't go all the way to the lowest setting if the slot was opened up a little bit, or the tab was ground down. The only other issue that I could see is if the tabs will hit the floor of the car with the lowest setting. If this is the only problem why couldn't you just cut the tab shorter so that it wouldn't hit? I would appreciate any installation advice, pics, or opinions.

Thanks,

Andy

In order to get it to the lowest setting on mine, I had to cut the tabs so all that was left was the lowest setting. Worked great.

I got my seats today and got them installed. A pretty easy installation. I cut the tabs on the slider so I could use the lowest setting on the adjustable sliders. I am going to have to get used to how the seats sit though, but I think I will like them. Below are links to a couple pics.

Andy



http://community.webshots.com/photo/95705837/106047982cweMGd

http://community.webshots.com/photo/95705837/106048028ulUrGA

to get mines to the lower settings i also had to cut