one of the two little nozzles that sprays the windshield washer fluid is sticking up out of my hood, not a lot, but it should be down stuck to the hood. any ideas what kind, if any glue i could use to stick it back down?
Thanks a lot in advance.

try taking the rubber gasket off of the bottom of the washer...the washer will sit better in the opening then. i did it on mine and it worked perfectly:thumbsup

How did you get the ones out of your stock hood, mine are still in the hood and seem to be a bitch to get out..

when i got my cf hood, i yanked the sprayers out of my stocker with some pliers}(

I guess I was just too lazy to think of that hahah, I was screwing around on the inside of the hood with a screw driver. Oh well, I don't drive the car enough to get the windows dirty, plus it's stored now so it doesn't matter.

dude....im kinda exposing my ricer past here (no offense) but when i had mine, i used a hole saw and cut through the hood support (stock hood) right underneath the holes themselves. my windshield kit (eurolites) came with nuts and washers. email me if you want pics, etc.... -hazard

once you take them out....they never sit in there the same.... mine always pop out....i had to take them out to paint the car, now everytime i close the hood the pop up, or if i hit any kind of bump...i hate the f**kers }(
doug

the OEM ones or the the glowing ones??? originally i took mine off 'cause the driver's side one stopped working..... LOL my oem ones on the passenger side actully spray up, over the top of the car...

my oem ones do that....but if you dont know, you can stick a small pin in the holes and adjust them???
doug

Silicone

I actually got a new set off of ebay for like 4 shipped...they worked great, and stay in place like no other.....i havent had 1 prob...just go onto ebay and type in washer nozzel...peace, BRIAN