ok guys ur gonna tell me to SEARCH well i did!!!! all i found was the HVAC led's well that is helpful but i can't get my cruise swtich apart to get to the led's. I got an extra one from an eclipse in a junkyard and it still works just great. So i have an extra one to mess with the led's.so i take out the individual switch for just the cruise and i take off the back from the tabs. I try to pull the circuit board thru to no avail. I don't want to break it but i really want to change these to blue since i have the blue needle kit and blue reverse indiglos and getting new autometer guages that will glow blue also. (i will worry about the HVAC later) So how do i get out the circuit board on the cruise button and the fog button???? is it still the 3mm 2600-3000mcd led? with a 330ohm resistor??? so any help from u guys would be great.. as long as i can get this done before saturday im all set! TIA


VW= The joy of driving
DSM= The frustration of fixing

*bump* sorry it was gonna drop to far on the page for people to care..


VW= The joy of driving
DSM= The frustration of fixing

Let me look at mine in the morning and I'll get back with you.

there are 4leds .. well 3 really small leds and one bulb if i remember correctly.. you may need to remove the bulb before the circuit board will slide out properly.. the really small leds you will have to look around for.. i think they are the 3mm leds while the reg bub will be replaced with s standard 5mm led.. i have some pics.. but they are not the best of when i was messing with mine.. just be careful as i messed mine up the first time.. well it took me messing with it a few times before i messed somethign up.. and in the end i just decided to leave it alone..

http://www.iamnotwhoiam.net/PhotoAlbum/cars/jason/projects/Dash%20Lights.htm

http://www.iamnotwhoiam.net/PhotoAlbum/cars/jason/projects/Dash-lights/

just going to have to look around for the pics you are in need of as there are a few of them and they are large in size so if you have dialup.. be prepared to wait..

thanks for the pics but it's kinda hard to tell how u got them out. if i can i will make a how to but that's only if i can get the switches apart. im gonna keep trying. thanks


VW= The joy of driving
DSM= The frustration of fixing

Carefully take off the front of the switch. the board probably won't come out because it is getting held up by the 3 led's on the front. Sometimes they catch on the main housing. That is the only reason I can see for it not working. Good luck!

hey jersy i was able to get out the board with NO cutting and NO breakage!! when u take apart the switch u will see a thing that looks like a screw. well turn that all the way to one side, then get something to pry it out.. it's another LED. once that led is out then u can slide the board right out. it's cake to bad it took me this long to realize it. now i just have to order all the LED's and it will be nice.


VW= The joy of driving
DSM= The frustration of fixing