need to know if the part of the door panel that is cloth will harden if resin is applied to it, im thinking of glassing it.

yea it would harden as far as sticking to it that would be my concern

hell yes it will harden that shit will be hard as hell w/that resin on it, almost like superglue lol, do you want to make a mold of it or do you want to apply the glass onto it?

apply the glass to it what i plan on doing is drilling holes in to it so that the resin goes thru and grabs on incase it dont hold but i think it will has anyone done this

also on another note has anyone fiberglassed their visors

It should harden, but make sure you add a layer or three of mat and resin.

>It should harden, but make sure you add a layer or three of
>mat and resin.


yup will do.

I was fiberglassing all day, you guys will see what later. but i did start on the door panel. I put resin on it and left it to dry. Havent checked back on it, but it looked like it was drying good. I put a few holes in it to let the resin resinate thru to grab on, honestly its looking good.

btw, i love fiberglass

>also on another note has anyone fiberglassed their visors

Working on that right now

let me know how it works out man, i plan on doing that tomorrow along with my rear deck, and door sills.....opps i've said too much

yeah, it going pretty well now, I'm getting rid of the mirror...I was kinda afraid it wasn't going to stick very well but when utake off the fabric there are lots of nice little hole for it to grab. But i also ran a dremel cuttin tool down horizontal lines across it for that extra grab.

yea thats what i did for my door sills drilled holes then ran lines with my dremel, worked good

its been about a week since i have even seen my little project..its at my ex-work still and i haven't talked to my friend lately. I need to find a place where I can go and fugg with it whenever i want.