alright, i tricked you, i need some help. where did everyone mount their boxes? how did you run the wires. i got my kit and want to install it tomorrow. all thoughts welcome.

i just left mine sitting there in the engine bay near the headlights. it's pretty snug. you *could* mount them if you wanted but it'd be a PITA to drill in there prolly. the wires aren't that long so there's not much you can really do with the ballasts...

-marc

='95 RS 5spd Red=
Matrix CAI
A'pexi Turbo N1
Hanabi 8000k HID
SPAL Deluxe Power Windows
Nakayama GT5 17's
Ractive STB
GSX Calipers
AEM Rotors

255 is fricken short

pics are good...:thumbsup anyone else??

I mounted my driver side ballast under the fuse box. Then when I had my bumper off...I found that the ballast fit perfectly in the cut out area of the support that hold the bumper support bar. So I mounted the passenger side ballast on that bracket and the wires went up through a hole that was already cut out and it worked out great because you couldn't see the ballast and there was just enough wire to make it so there wasn't tons of wires hanging everywhere. Just put double sided sticky tape all over the bottom and sides of the ballast and jam it into the bracket and it'll be there for ever.

i am just kinda worried about them falling off and putting stress or worse breaking the wires. i hope i can do this ok. i dont want to take off my bumper. if i want to put an msd ignition in front of my ecu, will putting the ballast underneath the fuse box interfere with the room to do it?


EDIT: i just thought of another good idea!!! zip ties!!!! :thumbsup

bump

You don't have to take the bumper off to put them there. I just had the bumper off when I was putting in the dual projectors, when I had them.

how do you like the dual projectors???

what does the fuse go in? i have a 20 amp fuse that came with the kit and it doesnt say anything about it in the instructions. i want to install these in about 15 minutes. help please. thanks

talon614: I don't have the dual projectors anymore. A redneck in a 4x4 took care of them. They weren't bad when I had them though.

Diceman19: I didn't use the fuse. I actually don't know anyone that used the fuse either. Just plug them in and you'll be good.

ya mine didn't have a fuse either... if there's a problem you'll just blow the headlight fuse. i know some people with HID's had problems if they turned on their HID's a foglights at the same time (just from the large current when you first turn them on). if you turn them on separately it was fine though.

-marc

='95 RS 5spd Red=
Matrix CAI
A'pexi Turbo N1
Hanabi 8000k HID
SPAL Deluxe Power Windows
Nakayama GT5 17's
Ractive STB
GSX Calipers
AEM Rotors

255 is fricken short

I am sure you guys want to see some install pics so I was able to get two loaded. Here you go, dice...;-) Looks killer!








http://www.cardomain.com/id/jasvbts2k2
"The ONLY Honda I'd mod would be ASIMO"

thanks mang! it is so hard to believe that is my car. it looks so good in the dark. lol. anyways. i got them in. they are awesome. definetly do it. it is such a PITA but it is so worth it to have night time vision. laters.

PS. where can you get replacement bulbs or information from hanabi directly. i cant find their website anywhere and i am sure the bulbs are proprietary cuz of the wiring harness. (manufacturer specific)