Just wondering -- how does one go about doing this -- do I just take a dremel to it??? What kind of bit do i use??? Any type of special polish or something I put on near the end -- a how-to would be ver nice -- thanks guys.

Your going to have to sand off all of the powder coating which is a bitch. Start with a really gritty sand paper like #66. Sand until you have all the poweder coating off. Then keep stepping up to finer grits and sand the scratches off from the last grit until you get to #1200(#2400 would be better but it's hard to find). Then polish the hell out of it with a good metal polish like Mothers of something similar. I find that when using sand paper to polish metal it works best to use really short fast strokes to the point where the friction burns your fingers.

or you can just buy the kit at summitracing.com it's the port and polish kit for like 36bucks... nice kit full with bits for your dremmel or drill...........

Yeah, but then your forearms won't be sore for a week.

you can also have yr cover sandblasted then polish it.. might cost a lil more..but u wont have those sore arms..and u can have it done quicker..