How do i take the stock sideskirts and bumpers off? the truck company called me and told me my kit will be delivered tomorrow, so im ready }( ill be up all night goofin around and installing it, so it would sorta help if i had a heads up on what to remove to take the stock shit off, and put cool shit on :P

take the obvious bolts off the front. Then, there will be bolts under headlights and in center area. And on the front fenders. Probably a good idea to jack it up.

Sides- take bolts off on the fenderwells and then pull so the tabs pull out???

Rear- Never done this. I assume the bolts are accessed after removing the tail lights or from under the car. Probably very similar to the front. You are going to more than likely remove your reinforcement bar on the front and possibly the rear.
Have fun. :thumbsup

the sides have screws by the front wheel wells, they are visible to the casual observer. then there are bolts on the bottom of the car. you have to jack it up to get to them with a drill. then just pull hard on the plastic tabs.

you have to take out all three headlight pieces to get to the rear bumper bolts. or maybe just the outer two, im not that sure. then there are some screws in the rear well that connect the rear bumper to the splash guards. take those out

the front is probably the easiest. 5 across the top under the hood, a lot underneath it, and the two on each side that are connected to the fender. you probably need to take the sidemarker off first to get to it.

but damn dude, its too fkn cold to do that shit

yeah it is pretty damn cold around here lately, im pulling the car into the garage to do this mess....sooo hopefully itll go swiftly

I beleive they took Brynden's rear bumper off without removing any taillights.

What is the best way to get to the bolts under the headlights?

click on the link in my sig then find where it says 2g_Exterior.pdf
it should have everything you need to know.

i have a chiltons on the way i nthe mail :P

>i have a chiltons on the way i nthe mail :P


it doesnt help much

take it to the body shop and have them install it and mold everything on except the front bumper..... you'll appreciate it alot more if you mold.... looks a lot nicer