Hey Guyz just spent an hour making some angel eyes for my car. The process is very simple. The tutorial that was posted earlier is very cool. I made my dashes in the "blind wand" a little too close. I think the spaces need to be further away. I tried useing the LEDs but for some reason they kept frying. No idea why. I used a christmas tree light and it seemed to work, but it obviously wouldn't go in my car. The Light going in the ring just doesn't seem bright enough. Any suggestions on a bright light source, or are LEDs the brightest and I'm just going to have to figure them out. O, and after i got done with one, and i taped the light on to test it, i went to pull the tape off. SNAP the ring snapped in three. Gotta make a new one. That's it. I'll post some pics when I finish em.

Full Blitz Urethane Bodykit Neo Combat VR Spoiler Projector Headlights Altezza G2 Taillights (soon to be Eurotec) Limited 17" Chrome Wheels Toyo Proxes 215/45 Tires 80% Tint all around Purple Undercar Neons (uh Broken) Custom Chameleon Vinyl Graphics Custom Chameleon Paint White Face Gauges with 5 Colors 2 5.6" Tvs In The visors Playstation 2 in Air Bag compartment Pioneer Headunit with DSP 12 Disc CD Changer

WWW.WICKEDSTYLZ.COM

5 1/2" Kicker Impulse Front Speakers 1" Kicker Titanium Tweeters 6X9" Kicker Impulse Back Speakers 2 12" Kicker L7s Kicker 354XI 4 channel Amp Kicker 800.2 2 channel Amp Cold Air Intake Arospeed Exhaust Purple/Green Wire Loom Air Suspension (not yet installed) Viper 550 Security Alarm with Keyless entry and Remote Start Motion/Proximity Sensor

Each LED have a resistor inline. I suggest a 330ohm resistor.

i used 30Ma leds and 330 ohm resistors.
later

my question is how the hell do you guys get them inside the headlight? is that hard? those blue angel eyes look tight, i would get pulled over in a sec though