i know the 2 peices on the body are bigger than the low wing, my question is do they and the actual spoiler part all mount in the same holes as the low spoilers?? oh, and where did you get them for how much?

I know you can get the wing from Wings West www.wingswest.com

1999 Mitsubishi Eclipse GS 10th Anniversary OZ Edition
Check Out My Site For Pix
http://mywebpages.comcast.net/EclipseRaceR/MyEclipse/

you have to drill new holes for the mid wing.

Ken

5zigen rearsection/Cherrybomb glasspack resonator/Bosal header/injen short ram intake/ported TB/AFX UDP/Fidanza cam gears/Power Stop cross drill rotors(front)/shunk2 coilover/Koni adjustable (front)/KYB struts(rear)Konig V-racing front bar/rear upper bar/painted black Enkei RSF2 17" with Kumho/ Nakayama projectors headlight/K2 8000K HID kit /WW 3 pieces wing/interior mods

well even though you have to drill new holes is it possible to avoid having to repaint everything since it will cover the holes??? I know it would be better if they were welded shut and repainted, but I really dont know how all this works out.

Right, I didn't repaint aanything tho.

Ken

5zigen rearsection/Cherrybomb glasspack resonator/Bosal header/injen short ram intake/ported TB/AFX UDP/Fidanza cam gears/Power Stop cross drill rotors(front)/shunk2 coilover/Koni adjustable (front)/KYB struts(rear)Konig V-racing front bar/rear upper bar/painted black Enkei RSF2 17" with Kumho/ Nakayama projectors headlight/K2 8000K HID kit /WW 3 pieces wing/interior mods

Yeah I got it.

The only problem you will have if you have the Crappy factory 3-piece spoiler, when you take of that spoiler - notice there is now a hole in the middle of your trunk.

With the New 3-Piece Mid Wing (Got mine from Wings West 4 years ago for $300.00 shipped) there's now need for that hole on the trunk.

You will need to have it filled and the entire trunk lid painted. (Will cost about another $40-$50 bucks to fill and paint that trunk.)

I love it, Looks really NICE especially on a SPYDER.



Later,

I thought the 3 piece mid wing by wings west will fit in all the factory holes?

Only the two in the middle will have to be filled.

yap, it supposts fit the stock holes. However, it didn't hmm

Ken

5zigen rearsection/Cherrybomb glasspack resonator/Bosal header/injen short ram intake/ported TB/AFX UDP/Fidanza cam gears/Power Stop cross drill rotors(front)/shunk2 coilover/Koni adjustable (front)/KYB struts(rear)Konig V-racing front bar/rear upper bar/painted black Enkei RSF2 17" with Kumho/ Nakayama projectors headlight/K2 8000K HID kit /WW 3 pieces wing/interior mods

The 3 piece doesn't even come close to using the factory holes. The image below is what I had to do to get the wing to fit (the red is the factory holes/black the Wings West). The only holes that I was able to use was the back 2 on the center piece. All the others either had to be re-tapped except for the back 2 on the side pieces. Those 2 We just enlarged for fine tuning the final placement.

Love the wing though ;)