| Go back to previous topic |
| Forum name | Interior/Exterior |
| Topic subject | Gauges colors |
| Topic URL | https://forums.2gnt.com/dcboard.php?az=show_topic&forum=i7&topic_id=30762 |
30762, Gauges colors Posted by Snail_GS, Sep-10-02 02:17 AM
I just took apart my gauge in my OZ 99 GS and I notice that some of the bulbs have those pastic comdom looking things on them is there any web sites i can get some red ones. If not any ideas on how i can make a custom one?
thanks
|
30763, RE: Gauges colors Posted by EvuLFleA, Sep-10-02 04:20 AM
Autometer or else some performance store should sell them.
|
30764, RE: Gauges colors Posted by Ryan_Hes, Sep-10-02 05:28 AM
Even if you replace the orange covers with red covers, it will sitll shine through orange. The back of the gauges have a think transparent orange layer of plastic that you have to sand off with sand paper in order to allow different colors to shine through. I plan on sanding mine once I get on my feet financially and go buy some supplies; then placing a clear blue <;astic sheet behind the gauges to yield a blue illumination. Be careful with the front of the gauges tho, our gauges are nice and silver :-)[br />
|
30765, RE: Gauges colors Posted by djtrickee, Sep-10-02 10:00 AM
I just did this over the weekend. I used the method of taking finger nail polish and q tips to wipe off the orange paint. I didnt even have to remove the needles. They are currently all clear and I put Blue LEDs in place of all the little bulbs in the back. I got over zealous thought and accidentaly broke about half of my fuel gauge needle off... DOH!! Anyway they look pretty sweet but I am going to go back and paint the backside blue to give it more glow. Anyone know where I can get a new fuel gauge needle?? -Chris b.
|
30766, RE: Gauges colors Posted by Ryan_Hes, Sep-10-02 02:19 PM
Finger nail polish worked?
|
30767, RE: Gauges colors Posted by djtrickee, Sep-10-02 06:01 PM
Sorry my bad. - I meant to say finger nail polish remover. I put aluminum foil over the gauges themselves in case i dripped some. Then i just took the q-tips and dipped them in the remover, and slowly rubbed it between the bottom of the needle and the aluminum foil. After a couple of seconds you will notice it starting to come off. Just takes patience and a steady hand. Thats how i broke the tip off the Fuel Gauge needle... I was too hasty. -Chris b.
|