the instructions say take bumper cover off... do u really have to?

how do i install the grillcraft center piece without having to take off the bumper. those who have it.. please respond.

'98 GS AT.Magenta Gray Pearl.Accel Spark Plug Wires.NGK Plugs.AEM Short Stack.GS-T Exhaust.AFX Underdrive pulley.RRE Front Lower Bar.Tenzo Rear Upper Bar
Tenzo Rear Lower Bar.Tenzo Front Upper Bar.Energy Suspension Bushings.Energy Suspension Motor Mounts.Radius Rims.Pirelli P7000 Supersports.Eibach Pro kit Springs.KYB GR2.$15 camber mod.TB (waiting to be bored and installed) http://www.ebalita.net

When I had my center piece of my grill craft grill on, I didn't take off the bumper. I ended up taking it off after I got my turbo so everyone could see my front mount intercooler! All that I did was jack up the front of the car and lay down under it and kind of pull the bumper out a little. I heated up a nail to poke a hole through the bumper to make it easier to get the screws in. It was really easy to do without taking the bumper off. If that didn't explain how good enough email me at jasonsanderholm@cox.net and I'll try to explain it better. Good luck!

No you do not need to take off the Bumper - The screws that they give you are very sharp. Just screww them into the bracket from the outside in. Once installed, you will never see the screw. There's one for each side and one on the bottom of the grille:





Took me like 5 minutes to install it. (It's been on there for 4 years now).

Later,

wheres the best place to get a grillcraft grill??