Hey all I just put in my order for my new kit but there is some things I don't know about it. 1 do the stock fog lights have to be moved? 2 what about the side markers (gone right) 3 how low is it going to be with the stock hight? Thanks for your time and this is some thing I realy need to know

yes, yes and only a couple inches

Chris
Project RS
http://klipzracer.homestead.com/index.html
"Now wobble, wobble........and drop it like it's hot."
chrisdishmon@hotmail.com

Hey chris thanks man. I love that wing dude what type is it APR? if so how much was it?

i have the blitz and did not have 2 move my fog lights, they sit right behind the dividers from the big and small mouth cut outs,, i just left em in,, cant see them at all,, as for the side markers, u have 2 take them out,, i also left my bumper support in, but i had 2 cut 2 get that 2 fit

Yup APR GT1

Chris
Project RS
http://klipzracer.homestead.com/index.html
"Now wobble, wobble........and drop it like it's hot."
chrisdishmon@hotmail.com

the kit probably wont be more than an inch lower than stock, actually probably about the same. just dont install the kit until you lower it though.

http://www.geocities.com/blue2gnt

I think I might get some airbags becuase up here in Maine the roads suck big time. if any one knows what is a good type I would like to know what they are. As for the fog lights, If I have them on would it light up behind the bumper (I think I would make them into Strobes). thanks guys

check out http://www.dzmotorsports.com for Sub Zero air bags. There are avaiable for our car for basic=$1500 fast bags=1800 and 4 wheel control=2000+

Ian
95 Eclipse RS
http://www.geocities.com/icjeclipse/index.html

Does the blitz kit's sideskirt need door caps?

I don't know man, I just want to know how hard is it to put the side skirts on. I am going to get them painted but I will put them on so I can save up for some rims. If any one could help us out here we would love it . thanks guys

no you dont have to have door caps, there may be a small gap behind the skirt where it meets the door and rear fender, but its worth it for the non door cap look you get, i love the car without caps and wish mine didnt have them. installing them is simple, unless you are molding them. just put screws in as many places as you can that are out of sight, as well as a couple in the front fenderwell and on top of the scoop in the rear.

http://www.geocities.com/blue2gnt

cyan..how do you cover up all the screws? It must look ugly with a screw in the top of the scoop??

-Justin