This may B a bit stupid, but ;)...

I've installed them running off the front sidemarker & they keep blowing the fuse as soon as I turn the lights on.

I just gave myself some slack & snipped off the wires (including the circuit board) @ the light & ran my own down. Also, I don't have each light running 2 their own sidemarker, I've got the passenger side connected 2 the driver side, & from there down 2 the driver sidemarker. The negative is grounded 2 the chassis.

Here's the Q's:
Is the little cirtcuit board that's included required 2 have these things work?
(I thought this was just 2 make them blink w/ the turn signal)

Does each light have 2 be run 2 it's own sidemarker?
(Don't think it matters)

Did I just tap in2 the wrong wire on the sidemarker?
(Don't think it matters)

Do I need a bigger fuse?
(Didn't want 2 go 2 high, might cause damage)

I've tried putting in a 30 fuse instead of the 15, but still blew. Sorry, I can't read the Japanese/Chinese instructions that came w/ it... didn't think it'd B a big deal anyways.

Thanx 4 the help,
- J

to get them to work you need to get at least 1 Type-R badge, that will fix your problem

While I won't B putting any R's on my car, I wouldn't mind a 2.4L or an RSX badge... after accompanied w/ the 2.4 short block or driveaxle, of course ;)

Still open 2 help on the the squirter lights also, pleaz...

Thanx,
- J

Was going through your site (HH21)... where & how much did U get your infrared camera 4?

- J

You read my mind HondaHater

you can get the infared cameras of ebay for 20-50 buck depending on features