I've got hold of a HOMELINK equipped visor which I had hoped would go straight on my RS, but I need to know what the single output wire connects to. Do I need to get an additional electronics box to get the thing to work? Any help would be greatly appreciated.

Thanks

FK_Ped:-)

nope, you just need 12v ran to that one wire. it get's it's ground from where you mount it. all the hardware is built in the visor. I don't remember how to program it. I'm sure someone else can expound. oh, one other thing, did you pull it off an eclipse, or an avenger? because the avenger has a three screw mounting plate and ours it a two screw setup. the plate will swap directly though. hope this helps.

other than garage openers.. what else can you use the homelink for?
wondering if i can use it to control other stuff.

'98 GS AT.Magenta Gray Pearl.Accel Spark Plug Wires.NGK Plugs.AEM Short Stack.GS-T Exhaust.AFX Underdrive pulley.RRE Front Lower Bar.Tenzo Rear Upper Bar
Tenzo Rear Lower Bar.Tenzo Front Upper Bar.Energy Suspension Bushings.Energy Suspension Motor Mounts.Radius Rims.Pirelli Tires.Eibach Pro kit Springs.KYB GR2.$15 camber mod

Thanks Koolade

It was off a 97'GSX I believe and bolts straight on my 99'RS. I was hoping all the stuff would be in the visor itself!

Cheers

Fk_Ped :)

do you think you could post pics on your install? I have an RS as well and I'd like to know how to go about this...

Does the +12v need to be permanent or switched?

Thanks

Fk_Ped

i use mine for my garage, my dads garage, and the gate for the community i stay at........

"borrow" a freinds keys and program the panic button for his alarm into it. :)

-Tony 98'GST
eclipzgst@charter.net

I'll scan my directions and email them to you later tonite. It's easy though and I have a toll free number you can call if you still can't get it done.

I hardwired the 12v so I can use it whether the car is on or not. and you really can't use it for much other than garage door openers because of the limited frequency range. if you have a really really old alarm, you may have one that uses that frequency group and be able to program it.

email me, I'll send the directions back. My email is all f***ed up.
I can't attach a file to the board email
the phone # is 1-800-355-3515