Just thought I would share a Northwest creation that was a complete DIY. I talked to this guy from Oregon in the parking lot of Alta Sports and he has done all the fiberglass molding himself. The dual exhaust is a Y at the downpipe and duals straigtht back. He had to alter the car to do it and is obviously not AWD The sub enclosure is sick as well as it's two tubes that are glassed into a rear deck in red, very tight. It was either an RS or GS but it is T'd at this point and runs low 14 if I remember right. All in all a very impressive DIY from the Northwest.

This was posted at DSMTALK. Looks good imo.

Anyone know what kind of rims those are?

Can't find those rims anywhere, and body have an idea of the brand???

check with O-Z, they make one that looks almost exactly the same and in different colors

Kasai, that body kit is a blitz style with what looks like some type of wide body kit

yeah its a blitz kit (not that he asked) but its not wide

i wanted to do that conversion so bad but too much fuckin money

my bad about the body, i thought it was and body, not anybody. i guess it would help me to read these at a time that wasn't 4 in the morning!

tell me again what kind of wing that is?

same wing i am getting soon :P

are you sure its not a wide body, cuz if you look at the doors it seems the fenders bulge out a lil more than stock

That is the GTR wing. The wing that i am selling for $150 to anyone in Southern Cali.

I am in love with this car now I may end up doing the supra tails this winter even though I had planned on trying the s2000 conversion.

ic any chance you would ship that wing?

please put into consideration that taillight conversions require molding the rear bumper

or moldin the tailights

now how da hell are you going to remove the bumper if it cracks or some idiot rear ends u (knock on wood)

my friend had the blitz rear molded in. He hit a pit bull tho and busted the front, dragged the poor beast under the rear and finally, the klipz shit him out. Pulled the bumper off the bolts, busted a hole in the middle of the rear and pulled the molds loose pretty clean. He just slapped the stock rear back on. and got the sinsei front.