Go back to previous topic
Forum nameInterior/Exterior
Topic subjectBulbs sizes?
Topic URLhttps://forums.2gnt.com/dcboard.php?az=show_topic&forum=i7&topic_id=10863
10863, Bulbs sizes?
Posted by icjeclipse, Dec-18-01 02:43 PM
Hey guys, can someone please tell me the bulb size code for the following bulbs: headlight corner bulbs, front bumper corner bulbs, gauge cluster bulbs(and how many), hvac cluster bulbs(any how many), and interior ceiling bulbs. Thanks
10864, RE: Bulbs sizes?
Posted by EvuLFleA, Dec-18-01 02:59 PM
Haha did you lose your manual or just too lazy?
Ill let someone else look them up due to ND being too cold and me being too lazy.
10865, RE: Bulbs sizes?
Posted by icjeclipse, Dec-18-01 03:01 PM
are they in there? YEa i am lazy. I will check that then.
10866, RE: Bulbs sizes?
Posted by eclipse804, Dec-18-01 04:12 PM
In the clear corners, it uses the small push in type (forgot bulb number). It's the same as used in the interior near the ground when the door is open. Also, the turn signal bulbs should be 1157 dual filament bulbs.
10867, RE: Bulbs sizes?
Posted by EvuLFleA, Dec-18-01 04:25 PM
Hey Ian want to tell me how you cleared out your headlights. Did you use Jason's write up on doing it?
10868, RE: Bulbs sizes?
Posted by icjeclipse, Dec-19-01 04:29 PM
i tried heating it up and pulling but it didn't work to well(maybe my mom's mairdryier wasn't warm enough) So i drove to my friends house and used a dremel and cut the whole back section of the tailight where the corner is. THen took out the orange lens, and then used Peramex Clear RTV silicon to seal it back up and to glue it back together.